I was disappointed with Swanstrom Disc Cutter at to start with, however it has ended up being shockingly powerful. After some experimentation, I would now be able to utilize it to idealize circles almost inevitably. The main drawbacks are that because of the openings being found so near one another (and one of them RIGHT beside the strong edge) you can’t really utilize it to punch a littler hover through a bigger circle. Be that as it may, at the cost, this is an extraordinary instrument
Client tips: 1) USE BABY OIL. Unfailingly, everywhere throughout the attachment. It has an immense effect. 2) For ~22 ga copper/silver/~24 ga bronze/metal or thicker, ANNEAL FIRST (burn fire). The metal will battle you considerably less. 3) The initial couple of times in any event, you should need to draw a hover on your metal, with the goal that looking down through the opening you can see whether your metal is focused. Despite everything I do this with the silver given how costly it is. 4) Use a HEAVY BRASS HAMMER to punch through the attachment. A steel sledge will work solidify the attachment, shortening its life, and a rawhide hammer simply doesn’t hit sufficiently hard. A two pound metal sledge purchased at the tool shop for $12 works flawlessly to punch through the module one attempt. The rawhide hammer took various tries, prompting scarring and twisting on the metal. 4) Mark the highest points of the attachments with the goal that you know which end you can hit. 5) Do any finishing of the metal AFTER you have removed it of the circle shaper. I had a go at moving surface onto 30 ga copper and afterward punching out circles, and lost a large portion of my surface. Punch in the first place, move/pound/draw second.
Likewise the initial couple of times you do this I’d recommend utilizing a modest metal (copper versus silver) and having two individuals. I dropped one of the attachments on the bond floor the first run through, and I’m fortunate it didn’t damage the front line.
The Swanstrom Disc Cutter SE JT-SP307 Disk Cutter Set (7 Piece) cut ideal circles of different sizes each and every time with our plate shaper. Our plate shaper’s openings have been sharpened to make fine clean cuts. The punches are solidified for toughness. The base is callous and ground. Highlights of our Disk Cutter Set (7 Piece) include: (1) Disk shaper measurements: 1/4″, 5/16″, 3/8″, 7/16″, 1/2″, 9/16″, 5/8″ (2) Dimensions: 2.5″ x 2.5″ x 1″ (3) High carbon steel SE is focused on furnishing the client with the most ideal hotspot for esteem available. You will appreciate the quality, capacity and value of our SE JT-SP307 Disk Cutter Set (7 Piece). IPR Rights Notice: Important: Avoid getting fake things. Certifiable SE items accompany the SE logo on the bundling. SE is an enlisted trademark ensured by US Trademark Law.
Price Swanstrom Disc Cutter SE JT-SP307 : $37.76